Summers Superchisel - 5-Section Instrukcja Użytkownika Pobierz pdf (Strona 42)

2-30

SECTION 2 – CONNECTING AND SEQUENCING WING LIFT

4. Before raising outer wings for the rst time, make sure wing lift cylinder attach eyebolts are

loose.

– Slowly raise part 2 wings into transport position.

– Fully retract part 2 cylinders and let wings rest against transport supports. Test adjustment

of sequencing valve before turning set screw. If valve is set with too much pressure, part 1

wings will not rise. To reduce the amount of pressure, turn set screw outward.

– With cylinders fully retracted and part 2 wings resting on transport supports, adjust cylinder

attach eyebolts so cylinders allow lift link rollers to rest on the bottom of slot. Tighten nuts.

5. Before raising part 1 wings for the rst time, make sure cylinder attach eyebolts are loose.

– Slowly raise wings by fully retracting part 1 wing lift cylinders, allow wings to rest against the

transport locks. If wing does not rest against both locks, adjust locks accordingly.

– Tighten cylinder attach eyebolts so cylinders allow part 1 wing lift rollers to rest on the bottom

of slot.

6. Lower wings to eld position.

– Make sure the part 1 wing lift cylinders fully extend before part 2 wings start to move. Test the

adjustment before turning set screw. If the valve is set with too much pressure, the part 2

wings will not unfold. To reduce the amount of pressure, turn set screw outward.

7. Fold and unfold machine again to make sure that everything is working properly.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 97 98

Brak uwag

Summers Superchisel - 5-Section Instrukcja Użytkownika Strona 42