Summers Superchisel - 5-Section Instrukcja Użytkownika Pobierz pdf (Strona 59)

PROBLEM CAUSE CORRECTION

A. Depth control cylinders out of

hase.

Rephase cylinders. See Page 3-6.

B. Eyebolts not adjusted properly. Adjust with wrenches provided.

See Pa

es 3-8 and 3-9.

C. Gauge wheels not adjusted

erl

Adjust gauge wheels so they ride

freel

on to

of the

round.

D. Hard soils conditions. Use different tillage tool or perform

multiple passes, starting at less

th.

2. Not

ullin

strai

ht.

. Chisel

low not tillin

level. See "Not tillin

level" above.

. Excessive travel s

eed. Reduce s

eed.

B. Hard soil conditions. Use different tillage tool or perform

multiple passes, starting at less

th.

C. Deep furrows. Travel across field furrows at an

le.

A. Working in extremely heavy

trash.

If equipped with mounted harrows,

reduce aggressiveness of harrows

or lock harrows in the up position.

B. Tillage tool (spike, sweep, etc.)

causing plugging.

Change type of tool. Make sure

twisted spikes are not throwing soil

towards wheels.

A. Machine not running level front

to back.

Adjust eyebolts on front center

wheel assembl

B. Gauge wheels adjusted

erl

Adjust gauge wheels so they ride

freel

on to

of the

round.

C. Hard soil conditions. Use different tilla

e tool.

A. Depth control cylinders out of

phase.

Rephase cylinders by fully

extending and holding tractor

remote lever for 30 seconds.

B. Hydraulic hoses not connected

properly or faulty coupler.

Reconnect hydraulic hoses or

replace hydraulic coupler.

C. Tractor hydraulics not set

properly.

Adjust tractor hydraulic flow rate to

maximum on Depth Control Circuit.

A. One way restrictor(s) not

installed

erl

Check restrictor(s) (PN 8J7116).

B. Tractor hydraulics not set

erl

Reduce flow rate to Wing Lift

linder Circuit.

A. Part 2 wing lift cylinder moving

before part 1 wing lift cylinders fully

extend.

Increase pressure in sequencing

valve that feeds base end of part 2

linders.

B. Part 2 wing lift cylinders not

extending.

Decrease pressure in sequencing

valve that feeds base end of part 2

linders.

A. Part 1 wing lift cylinders moving

before part 2 wing lift cylinders fully

retract.

Increase pressure in sequencing

valve that feeds rod end of part 1

linders.

B. Part 1 wing lift cylinders not

retracting.

Decrease pressure in sequencing

valve that feeds rod end of part 1

linders.

8. Wings do not unfold

properly.

9. Wings do not fold

properly.

6. Depth control

cylinders not working

properly.

7. Wing lift cylinders

move too fast.

1. Not tilling level.

3. Inconsistent tillage

depth.

4. Plugging.

5. Poor penetration.

5-1

SECTION 5 – TROUBLESHOOTING

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 97 98

Komentarze do niniejszej Instrukcji

Brak uwag

Summers Superchisel - 5-Section Instrukcja Użytkownika Strona 59

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Maszyny specjalne Summers Superchisel - 5-Section